Large Eddy Simulations (LES) of film cooling flows were conducted to investigate the impact of high turbulence intensity in the main flow, representative of jet-engine combustor conditions. A comparison was made with LES simulations at zero turbulence at the main flow inlet boundary. The study investigated three different film cooling configurations, which involved cylindrical holes and two variations with holes embedded in trenches known as transverse and segmented trench. Different momentum ratios ( and 8.3) relevant to combustor flows in jet-engines were applied. The LES simulations utilized OpenFOAM and solved the energy and passive scalar transport equations to determine film cooling efficiency (η), heat transfer coefficient (), and net heat flux reduction (). The numerical results were validated through comparison with experimental data. The mean and instantaneous results revealed that high turbulence intensity in the main flow significantly influenced film cooling performance. The film cooling efficiency was found to decrease with increased turbulence intensity, while for the ordinary film cooling design exhibiting jet lift-off, the increased mixing led to higher η. The heat transfer coefficient increased with turbulence intensity and momentum ratio, with turbulence intensity having a greater impact on ordinary designs and momentum ratio on trenched designs. Moreover, increasing turbulence intensity or momentum ratio resulted in lower for all designs. Hot spots were observed in the instantaneous results, with spatial variations depending on the film cooling design.    «

Large Eddy Simulations (LES) of film cooling flows were conducted to investigate the impact of high turbulence intensity in the main flow, representative of jet-engine combustor conditions. A comparison was made with LES simulations at zero turbulence at the main flow inlet boundary. The study investigated three different film cooling configurations, which involved cylindrical holes and two variations with holes embedded in trenches known as transverse and segmented trench. Different momentum ra...    »